Table of Contents
Advertisement
A wide variety of external equipment can be connected via the sockets located on the side and back of the
TV. Whilst all the necessary adjustments and controls for the TV are made using the remote control, the
button on the left side of the TV may be used for some functions.
Switching on
If the standby LED is unlit, check that the mains plug is con-
nected to the power and press the middle of the
on the left side of the TV to switch the television on. Then the
LED lights up in green. If the picture does not appear, press
button on the remote control; it may take a few moments.
To put the television into Standby, press
remote control. To view the television, press
The picture may take a few seconds to appear.
Note: The active Standby LED may appear for a few moments
when the TV is switched off.
For energy saving:
Turning the TV off at its mains supply, or un-plugging it, will
cut energy use to nearly zero for all TV's. This is recom-
mended when the TV is not being used for a long time, e.g.
when on holiday.
Reducing the brightness of the screen will reduce energy use.
Energy effi ciency cuts energy consumption and thus saves
money by reducing electricity bills.
NOTE: Putting the TV into standby mode, will reduce energy
consumption, but will still draw some power.
01_MB62_[GB]_(01-TV)_DVB_TC_(IB_INTERNET)_(26155LED_1911UK)_NICKEL17_10077727_10077398.indd 14
01_MB62_[GB]_(01-TV)_DVB_TC_(IB_INTERNET)_(26155LED_1911UK)_NICKEL17_10077727_10077398.indd 14
Controlling the TV
Press the MENU button on the remote control to see the
menus.
button
The main menu appears as a group of icons each for a menu
option. Press the Left or Right button to select a topic.
In sub menu screen mode the menu appears as a list. Press
the Up or Down button to select a topic.
button on the
button again.
To use the options press the Up and Down buttons on the
remote control to move up and down through them and OK
button, Left or Right buttons to select the required choice.
Follow the on screen instructions. The functions of each menu
are described in detail throughout the manual.
Using the Controls and Connections on the TV
Using the menu wheel on the side of the TV:
To change volume: Press the middle button until the
volume level OSD appears. Increase the volume by
pushing the button up. Decrease the volume by pushing
the button down.
To change channel: Press the middle button until the
channel information banner appears. Scroll through the
stored channels by pushing the button up or down
To change source: Press the middle button until the
source list appears. Scroll through the available sources
by pushing the button up or down.
To turn the TV off: Press the middle of the button down
and hold it down for a few seconds, the TV will turn into
standby mode.
Please always refer to the owner's manual of the equipment
to be connected for full details.
English - 14 -
Using the Remote Control
08.05.2012 14:55:51
08.05.2012 14:55:51
Advertisement
Chapters
Table of Contents
