Kenmore 79041032803 Installation Instructions Manual page 3

Models with glass cooktop - To avoid breakage: DO NOT handle or manipulate
the unit by the cooktop glass°
The counter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2) cabinet
sides (H1-4), front and back (see illustration 1) from the floor to the top
of the counter•
Level the range using the
four (4) leveling legs so
that the height from the
floor to the underside of
the cooktop glass is greater
than the tallest cabinet
measurement by at least
1/1 6" (see illustration 2).
Shave 1 1/2"Max.
Raised (3.8 cm Max.)
Edge
to Clear
Space for
311/2" (81 cm)Wid_
Cooktop.
Slide the unit into the cabinet. Make sure the
center of the unit is aligned with the center of
the cabinet cut-out.
Illustration 1
Remove the protective channels on each side of the glass
cooktop (if provided).
The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support• The glass cook-
top should NOT directly touch the countertop (see illustration 2) or
could cause glass breakage voiding the warranty• Level the unit if
needed•
To successfully install
the range, the initial
level height from
floor to underside of
cooktop glass should
be at least 1/16"
taller than cabinet
sides as measured in
step 1.
After the installation, MAKE SURE that the unit _s
supported by the leveling legs NOT by the cooktop.
Illustration 2
3