Advertisement
Available languages
Available languages
Anti-Tip
Brackets
Installation
Models
Equipped
with Leveling
Device
_To
reduce the risk of tipping
of the
range, the range must be secured to the floor by
properly
installed
anti-tip
bracket
and screws packed
with the range. These parts are located in the oven.
Failure to install the anti-tip
bracket will allow the
range to tip over if excessive weight is placed
on an
open door or if a child climbs upon it. Serious injury
might result from spilled hot liquids or from the range
itself.
Follow the instructions
below to install the anti-tip
brackets.
if range is ever moved to a different
location,
the
anti-tip
brackets
must also be moved and installed
with the range.
Tools Required:
Adjustable
Wrench
Ratchet
Drill & 1/8"(0,32
cm) bit
5/16"
(0,8 cm) Nutdriver
Level
The anti-tip
bracket
attaches to the floor at the back
of the range to prevent range from tipping.
When
fastening
bracket to the floor, be sure that screws
do not penetrate
electrical
wiring or plumbing.
The
screws provided
will work in either wood or concrete.
1.
Draw a center line (CL) on the floor where the
range should be installed.
Also draw a line on
the floor at the range back position if there is no
wall.
2.
Unfold paper template
and place it fiat on the
floor with the right rear corner positioned
exactly
on the intersection
of the center and back lines
you just drew before. (Use the diagram
below
to locate brackets if template
is not available.
(Figure 12))
3.
Mark on the floor the location
of the 4 mounting
holes shown on the template.
For easier
installation,
3/16"(0,48
cm) diameter
pilot holes
1/2"(1,27
cm) deep can be drilled into the floor.
4.
Remove template
and place bracket
on floor.
Line up holes in bracket with marks on floor and
attach with 4 screws provided.
Bracket must be
secured to solid floor (Figure 13). If attaching
to
concrete floor, first drill 3/16"(0,48
cm) dia. pilot
holes using masonry drill bit.
5.
Be sure the 4 levelling
legs are at the highest
position they can be.
6.
Slide range into place making sure structure
of the range is trapped
by the anti-tip
bracket
(Figure 12). Lower the range by adjusting
the 4
levelling
legs until the underside of the cooktop
is
sitting level on the countertop.
Refer to "Levelling
the Range" section.
7.
After installation,
verify that the anti-tip
bracket
is engaged
by grasping
the top rear edge of the
range and carefully
attempt
to tilt it forward
to
make sure range is properly
anchored.
Figure 12
Kitchen
Cabinet
Toe
Door
Plate
Cabinet
LIDE
BACK
C
0
P
:J
Range
Floor Mount --/
Screws
Figure 13
*--Wall
11
Advertisement
