Advertisement
Available languages
Available languages
Decorative
Rear Trim Installation
(if
required)
1.
Disconnect
the power from the range.
2.
Make sure the range is leveled.
3.
Pull range toward
you.
4.
Take the distance
between
the floor and the
surface
underneath
the cooktop
frame.
5.
Mark that distance
on the walt where the
decorative
trim will be installed.
6.
Draw a line.
7.
Place the top of the decorative
trim under that
line.
8.
Using the screws provided
fix the decorative
trim into the walt.
9.
Slide the range back into position
and
reconnect
the power source (the bottom
of the
cooktop
should be located
over the decorative
trim).
Dist _an_ .........
J
between
the
i
zsI -Z floor
and
_the
surface
_underneath
_q_
cooktop
Operation
of Oven
Elements
The oven is equipped
with an electronic
oven
control.
Each of the functions has been factory
checked
before shipping. However, it is suggested
that you verify the operation
of the electronic
oven
controls once more. Refer to the Use & Care Guide
for operation.
Follow the instructions for the Clock,
Timer, Bake, Broil, Convection
(some models) and
Clean functions.
Bake-After
setting
the oven to 350°F
(177°C)
for baking,
the lower element
in the oven should
become
red.
Broil-When
the oven is set to BROIL, the upper
element
in the oven should become
red.
Clean-When
the oven is set for a self-cleaning
cycle, the upper element
should become
red during
the preheat
portion
of the cycle. After reaching
the
self-cleaning
temperature,
the lower element
will
become
red.
Convection (some models)-When
the oven is
set to CONV.
BAKE/ROAST
at 350°F (177°C),
the convection
element cycles on and off and
the convection
fan turns. The convection
fan will
stop turning
when the oven door is opened
during
convection
baking
or roasting.
Warmer
Drawer
(some madels)-Set
the control
knob to HI and check to see the drawer
is heating.
When Power Connection
is Completed
Make sure allcontrols are left in the OFF position.
Figure 11
Check Operation
Refer to the Use and Care Guide
packaged
with
the range for operating
instructions
and for care
and cleaning
of your range.
Do not touch the elements. They
may be hot enough to cause burns.
Remove allpackaging
from the oven and the
warmer
drawer
(if equipped)
before
testing.
Operation
of Surface Elements
Turn on each of the four surface
elements
and
check to see that they heat. Check the surface
element
indicator
light(s), if equipped.
Model and Serial Number
Location
The serial plate
is located
on the oven front frame
behind the oven door (some models) or behind the
drawer
(some models).
When
ordering
parts for or making
inquiries
about
your
range,
always
be sure to include
the model
and serial
numbers
and a lot number
or letter
from
the serial
plate
on
your
range.
Before
You Call for Service
Read the Before You Call for Service Checklist
and operating
instructions
in your Use & Care
Gulde.
It may save you time and expense.
The
list includes common
occurrences
that are not the
result of defective
workmanship
or materials
in this
appliance.
Refer to your Use & Care Guide for Sears service
phone numbers, or call 1-800-4-MY-HOME
®.
lo
Advertisement
