Electrical Requirements - Kenmore 79031043805 Installation Instructions Manual

Check for leaks,Afterconnecting t herange to thegas
supply, c heck the system for leaks with a manometer. If
a manometer is not available, turn onthe gassupply and
usea liquidleakdetector ( orsoapandwater)at all
jointsandconnections to check for leaks.
Preferred Method
Grounding type
wallreceptacle
Donot usea flameto check for leaks
fromgasconnections. Checking f or leaks witha flame
mayresult i n a fireor explosion.
Tightenall connections asnecessary to prevent g as
leakage in the range or supply line.
Figure7
Power s upply cordwith3-
prong grounding p lug.
Disconnect t his rangeandits individualmanual
shutoff valvefromthegassupply pipingsystem during
anypressure t estingofthatsystem attestpressures
greater t han1/2psig(3.5kPaor 14" watercolumn).
Isolatethe rangefrom the gassupplypipingsystem
byclosing itsindividual manual s hutoffvalve duringany
pressure t esting of the gassupply pipingsystem attest
pressures equal t o or less than1/2psig(3.5kPa or 14"
watercolumn).
Electrical Requirements
120 volt, 60 Hertz, properly grounded dedicated circuit
protected by a 15 amp circuit breaker or time delay fuse.
Note: Not recommended to be installed with a Ground
Fault Interrupt (GFI).
Do not use an extension cord with this range.
Grounding Instructions
IMPORTANT Please read carefully.
For personal safety, this appliance must be properly
grounded.
The power cord of this appliance is equipped with a 3-
prong (grounding) plug which mates with a standard 3-
prong grounding wall receptacle (see Figure 7) to
minimize the possibility of electric shock hazard from the
appliance.
The wall receptacle and circuit should be checked by a
qualified electrician to make sure the receptacle is
properly grounded.
Where a standard 2-prong wall receptacle is installed, it
is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded 3-
prong wall receptacle.
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
Moving the Appliance for
Servicing and Cleaning
Turn off the range line fuse or circuit breakers at the main
power source, and turn off the manual gas shut-off valve.
Make sure the range is cold. Remove the service drawer
(warmer drawer on some models) and open the oven door.
Lift the range at the front and slide it out of the cut-out
opening without creating undue strain on the flexible gas
conduit. Make sure not to pinch the flexible gas conduit at
the back of the range when replacing the unit into the cut-
out opening. Replace the drawer, close the door and switch
on the electrical power and gas to the range.
7