Setting A Site’s Location - Uniden HomePatrol?1 Owner's Manual

Enter the LCN for the frequency and tap Accept. If you d
not know the LCN assignment,
for another frequency, then later use the LCN Finde
function to adjust the assignments.
The Frequency menu appears.
Edit Frequency – allows you to change the frequency.
Delete Frequency – deletes the frequency from the site.
New Frequency – tap to add additional frequencies, then
repeat the above steps.
Setting a Site's Location
You can define a site's location using either a single circle
(defined by the centerpoint's latitude and longitude and
the distance from the center, or rang
rectangles (each rectangle defined by
longitude of opposing corners).
At the Site Menu, select Set Location.
enter any LCN not used
r
e) or by using
the latitude and
o Then, select whether you will use a circle or rectangle(s)
to define the site's location.
If you select Circle, tap the existing coordinates.
Then, use the form to enter the latitude and longitude of
the circle's center.
Note, the format used to enter the location is set by the
button in the lower right corner of the screen. In this
example, we show coordinates using DMS format.
Select NEXT, then enter the range for th
(the distance from the center of the cir
ACCEPT the range to store the setting.
e department
cle to an edge).
46 | P a g e