HP DL360 Specifications page 10

QuickSpecs
Standard Features
System Fans System Fans System Fans System Fans
Required Cabling Required Cabling Required Cabling Required Cabling
Operating Systems and Operating Systems and Operating Systems and Operating Systems and
Virtualization Software Virtualization Software Virtualization Software Virtualization Software
Support for ProLiant Support for ProLiant Support for ProLiant Support for ProLiant
Servers Servers Servers Servers
Rack Airflow Rack Airflow Rack Airflow Rack Airflow
Requirements Requirements
Requirements Requirements
Rack Kit Rack Kit Rack Kit Rack Kit
9 fans ship standard; N+1 fan redundancy standard
For required cabling information, refer to the Web site at:
http://h18000.www1.hp.com/products/servers/proliantdl360/.
Microsoft Windows Server
Microsoft Windows Server Hyper V
Red Hat Enterprise Linux (RHEL)
SUSE Linux Enterprise Server (SLES)
Oracle Enterprise Linux (OEL)
Solaris 10 for x86/x64 based Systems
NetWare
VMware
Citrix Essentials for XenServer
NOTE: NOTE: NOTE: For more information on HP's Certified and Supported ProLiant Servers for OS and Virtualization NOTE:
Software and latest listing of software drivers available for your server, please visit our Support Matrix at:
http://www.hp.com/go/ossupport
Rack 10000 G2 series Cabinets Rack 10000 G2 series Cabinets Rack 10000 G2 series Cabinets Rack 10000 G2 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling
efficiency for rack-mounted servers. The 10000 G2 Series Racks provide enhanced airflow for maximum
cooling, allowing these racks to be fully loaded with servers using the latest processors.
CAUTION: CAUTION: If a third-party rack is used, observe the following additional requirements to ensure CAUTION: CAUTION:
adequate airflow and to prevent damage to the equipment:
Front and rear doors: If your 42U server rack includes closing front and rear doors, you must
allow 830 square inches (5,350 sq cm) of hole evenly distributed from top to bottom to permit
adequate airflow (equivalent to the required 64 percent open area for ventilation).
Side: The clearance between the installed rack component and the side panels of the rack must be
a minimum of 2.75 inches (7 cm).
CAUTION: CAUTION: CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This CAUTION:
arrangement ensures proper airflow. Using a rack without blanking panels results in improper cooling
that can lead to thermal damage.
NOTE: NOTE: For additional information, refer to the Setup and Installation Guide or the Documentation CD NOTE: NOTE:
provided with the server, or to the server documentation located in the Support section at the following
URL: www.hp.com/servers/dl360.
Quick deploy rail system provides tool-free support for racks with square or round mounting holes
(including Compaq/HP 7000, 9000, 10000 G2 and HP series), with an adjustment range of 24" - 36".
The ambidextrous cable management arm can be mounted on either the left or right side for improved
cable management.
DA - 12476 Worldwide — Version 67 — November 23, 2009
HP ProLiant DL360 Generation 5 (G5) HP ProLiant DL360 Generation 5 (G5) HP ProLiant DL360 Generation 5 (G5) HP ProLiant DL360 Generation 5 (G5)
and our driver download page www.hp.com/support/DL360G5.
Page 10