To Secure Lower Sash In Place, Attach Right Angle Sash Lock; Cut Foam Window Seal And Insert It Into The Space Between The Upper And Lower Sashes; After The Completion Of The Installation, Please Check The Machine's Lean; Trim The Weather Seal With A Proper Length, Peel Off The Protective Backing And Plug Any Gaps - Frigidaire Cra065At714 Installation Instructions

To secure lower sash in place, attach right angle sash lock with 1/2" (12.7 mm) screw as shown (FIG. 10).
NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad windows, so you can use lock by
window itself.
Cut foam window seal and insert it into the space between the upper and lower sashes (FIG. 11).
FIG. 10 FIG. 11
After the completion of the installation, please check the machine's lean as shown (FIG. 12A & FIG. 12B). It's
necessary for proper condensed water utilization and drainage.
FIG. 12A
o
OUTSIDE
1/4"~1/2" I
Rail
Wooden Window
I
FIG. 12B
INSIDE
\ ® e 5
OUTSIDE
-H2 about 1/4"~1/2 ''
H 1_ _ ]___Bottom
Rail
Vinyl-Clad Window
Trim the weather seal (6"X3/4"X1/12") with a proper length,
peel off the protective backing and plug any gaps if needed
as shown FIG.13.
Removing the air conditioner From Window
Turn the air conditioner off, and disconnect power cord.
Remove sash seal from between windows, and unscrew sash lock.
Remove screws installed through frame and framelock, o. . ...
Close (slide) side panels into frame.
Keeping a firm grip on air conditioner, raise sash and
carefully remove.
Be careful not to spill any condensate water while lifting
unit from window. Store parts WITH air conditioner.
/
!
i
\
FIG. 13