Installation And Adjustment - Haier XPB10-LAP User Manual

Installation and adjustment

Please install and adjust the machine according to the requirement of
the manual. It is very important to your security and correct operating
the machine.
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be
less than 10cm , or the drainage will
not be smooth enough and cause
incomplete drainage.
<10cm
2.Do not step on or press the drain hose.
Install the lint filter
After openning the package,please take out the lint
filter from the document bag,install it to the filter frame
of the cabinet.See to the figure.
Install the water inlet hose; Select the water level
Use the new water inlet hose provided with the
machine to connect to the water faucet.
Old hose sets should not be reused.
Insert the water inlet hose into the water-filling
entrance on the control panel directly. (pull it
out to dismantle it)
Select water level according to the
quantity of the laundries.
Attention:
In water filling, do not exceed
the"Maximum" water level. Otherwise
the water may overflow out of the
washing machine.
4
3 If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
4.If extra drain hose is needed , the inner
diameter of the extra hose shall not less
than 30mm, and the length shall not exceed
1.5m.
> 30mm
<1.5m
overflow filter
lint filter
Water-filling
Water inlet hose
entrance cover
Water-filling
entrance
Max
Maximum
Med
Medium
Min
Minimum
How to change the direction of the drain hoses
Figure 1 indicates the ex factory installation
position of the drain hose.
Extend the drain hose from the side of spin tub
Put soft items on the ground. Lean the machine
down gently with the front surface facing the
ground. Take off the drain hose from the cabinet.
Dismantle the drain hose fixing clamp and take
the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove along the side
of the spin tub in the order of (1)~(3), heading for the
side of the spin tub. (See to Figure 3).
Embed the drain hose into the groove with
hands. Take care not to damage the drain
hose in fastening the fixing clamp.
Extend the drain hose from the rear side
Dismantle the drain hose fixing clamp.
Take out the drain hose from the fixing groove.
Extend it from the rear side as per the direction
of the arrow. (When the drain hose is extended
from the rear side, it can be hung on the point
for drain hose at the two sides of the cabinet.)
(See to Figure 4).
Back
Soft item
Front
Figure 1
Drain hose fixing clamp
Soft item
Figure 2
Extend to the
spin tub side
Embed into the
groove in turn
Figure 3
Figure 4
5