Usage Of The Drain Hose - Haier HWM70-98 User Manual

How to change the direction of the drain hose
1.Lean the machine down gently with the front
surface facing the ground. Loosen the eight
screws by a cross screwdriver.
Back
Front
2.Pull out the drain hose from the groove at the left side.

Usage of the drain hose

The drain hose shall drain smoothly
1.The height of the drain hose shall be
less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.
2.Do not ramp or press the drain hose.
3.If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
3.Extend the drain hose from the right side. Push the
drain hose into the groove with hands.
Bottom plate
Soft item
Use groove at
this side after
4.Install the bottom plate (as per indicated before),
direction changing
then lift the machine up gently.
4.If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
Before Using
Before Using
Page 3
5.If the extra hose is too long, cut it
either at A or at B point.