Trouble Shooting Answer To Question - Haier HWM6000 User Manual

Trouble shooting Answer to question

(If there's breakdown, please pull off the power plug before checking) The following
phenomena are not breakdowns sometimes. Please confirm again before sending it to
repair. If there are real breakdowns, please come to the special maintenance department or
after-sale service department of our company. Do not repair it by yourself.
Phenomena
Buzzing upon reservation starts,
Nixie tube indicates "E0"
No or slow drain, nixie tube
indicates "E1" , buzzing.
Running pauses during spin,
nixie tube indicates "E2",
buzzing
Safety switch actuates, not spin,
(after self-correction twice),
nixie tube displays "E3", buzzing
No or slow water filling not
reaching the level in 15min
nixie tube indicates "E4",
buzzing
Poor or no waterfall flow
Not wash
The machine
does not act
Not spin
There's abnormal sound
inside the machine
The water faucet leaks
Common phenomena
Phenomena
The spinning is intermittent when it starts.
Push the "Procedure selection" button to
select "Spin", but it doesn't work.
There may be some water flowing out of
the drain hose in the first use of the machine.
While water filling in wash and rinse, the
pulsator pauses rotation
Wash pauses
The reason
The top lid is not closed
Is the drain hose put down?
Is the drain hose blocked
by foreign material?
The top cover leaves open
Are the laundries put
slantingly?
Is the machine slanting?
The water tap is not open
The water inlet valve is blocked
,
The water pressure is too
low and the current is
too small
If the nozzle is choked with
foreign bodies
Is there power failure?
Is the power plug loose?
Does the water level arrive at the
set water level?
Is the power plug loose?
Is the top lid closed?
Are the laundries put orderly?
Is the machine slanting?
Are the laundries slanting in
spinning?
Is the jointer screw of the water
inlet hose is loose or twisted
awry?
Explanation
Balance the laundries to avoid slanting.
The program is setting the drain time. Some time is
needed before it starts spinning.
It is the water remained in the factory inspection of
performance.
To prevent splash during water filling.
Supplementary water filling 48 s after
sensor tests cloth material.
15
How to settle
Close the top lid
Put down the drain hose.
Open and close the top lid once.
Clean the foreign material.
Open and close the top lid once.
Close the top lid
Re-order the laundries. Close the
top lid.Level the machine in right
position.
Open and close the top lid once.
Open the water tap. Push the
"Start/Pause" button.
Clean the water inlet valve.
push the "Start/Pause" button.
Wait for the normal water pre-
ssure before use.
Remove the foreign bodies
Use it when the power is on.
Insert the power plug tightly.
Affusion to the set water level.
Insert the power plug tightly.
Close the top lid
Put the laundries orderly.
Level the machine properly.
Re-order the laundries.
Fasten the jointer screw
properly.