Table of Contents
Advertisement
Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are
not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns,
please come to the special maintenance department or after-sale service department of our company.
Do not repair it by yourself.
Phenomena
The digitron displays E0.
The drainage cannot work, or is
too slow. The digitron displays E1.
Running pauses during spin, nixie
tube indicates "E2", buzzing
The safety switch acts, and
the spinning cannot work. The
digitron displays E3.
The water filling does not
work, or is slow. After about
40 minutes later, the digital
displays E4.
The digitron displays E6.
Not wash
The machine
does not act
Not spin
There's abnormal sound
inside the machine
The water tap leaks
Common phenomena
Phenomena
The spinning is intermittent when it starts.
The wash procedure pauses.
Select spin program, but it does not work.
The pulsator pauses during water filling in
washing and rinsing.
There may be some water flowing out of the
drain hose in the first use of the machine.
When the power plug is inserted, computer
board indicator is switched on, and the
machine starts working
The reason
The top lid is opened during
reserve procedure.
Is the drain hose put down?
Is the drain hose blocked?
The top lid is not closed.
Are the laundries put slantingly?
Is the machine slanting?
Is the water tap opened, or is
there water supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
The water level sensor is bad.
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset
position?
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Is the machine slanting?
Are the laundries put slantingly in
spinning?
Are there any foreign materials?
Is the screw of the jointer of
water inlet hose loose or awry?
Balance the laundries to avoid slanting.
The cloth sensor is detecting , it will add water
after about 48 senconds
The program is setting the drain time , certain
period is needed before it starts spinning.
It is to avoid splashing during water filling.
It is the water remained performance
inspection by the factory.
It is the special resume function.
failure or the power plug is loose during washing, the
machine can save the running program, and resume
the program after the power supply is recovered. You
do not need to set the program again
How to settle
Close the top lid.
Put down the drain hose. Open
and close the top lid once.
Clean the foreign material. Open and close
The top Lid Once.
Close the top lid.
Reorder the laundries. Close the top lid.
Set the washing machine horizontally
and then open and close the top lid
once.
Open the water tap. Open and close
the top lid once.
Clean the water inlet valve then open
and close the top lid once.
Open and close the top lid once.
Please contact the after-sales
service department.
Please use it when there's power
supply.
Insert the power plug tightly.
Fill water to the preset position.
Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
Adjust the machine to be even
Reorder the laundries and close the
top lid.
Remove the foreign materials.
Fasten the screw of the jointer
properly.
Explanation
In the case of power
15
Advertisement
Table of Contents
