Cannot Detect; Cannot Print - Brother MFC-6890CDW User Manual

Error Message
BT Call Sign On
(For U.K. only)

Cannot Detect

Cannot Print

Comm.Error
Connection Fail
Cover is Open.
Data Remaining
Disconnected
Document Jam
High Temperature
Hub is Unusable.
148
Cause
BT Call Sign is set to ON. You
cannot change the Receive Mode
from Manual to another mode.
You installed a new ink cartridge
too quickly and the machine did
not detect it.
If you are using non Brother
Original ink the machine may not
detect the ink cartridge.
An ink cartridge is not installed
correctly.
One or more of the ink cartridges
have reached the end of their life.
The machine will stop all print
operations. While memory is
available, black and white faxes
will be stored in the memory. If a
sending machine has a colour fax,
the machine's 'handshake' will
ask that the fax be sent as
monochrome.
Poor telephone line quality
caused a communication error.
You tried to poll a fax machine
that is not in Polled Waiting mode.
The scanner cover is not closed
completely.
The ink cartridge cover is not
completely closed.
Print data is left in the machine's
memory.
The other person or other
person's fax machine stopped the
call.
The document was not inserted or
fed correctly, or the document
scanned from the ADF was too
long.
The print head is too warm.
A Hub or USB Flash memory
drive with Hub has been
connected to the USB direct
interface.
Action
Set BT Call Sign to OFF. (See BT Call Sign
(U.K. only) on page 66.)
Take out the new ink cartridge and
re-install it slowly until it clicks.
Replace the cartridge with a Brother
Original ink cartridge. If the error message
remains, contact your Brother dealer.
Take out the new ink cartridge and
re-install it slowly until it clicks. (See
Replacing the ink cartridges on page 157.)
Replace the ink cartridges. (See Replacing
the ink cartridges on page 157.)
If the problem continues, call the
telephone company and ask them to check
your telephone line.
Check the other fax machine's polling
setup.
Lift the scanner cover and then close it
again.
Firmly close the ink cartridge cover until it
clicks.
Press Stop/Exit. The machine will cancel
the job and clear it from the memory. Try to
print again.
Try to send or receive again.
See Using the ADF on page 24.
See Document jam on page 153.
Allow the machine to cool down.
A Hub or USB Flash memory drive with
Hub are not supported. Unplug the device
from the USB direct interface.