Table of Contents
Advertisement
How to change the direction of the drain hoses
Figure 1 indicates the ex factory installation
position of the drain hose.
Extend the drain hose from the side of spin tub
Put soft items on the ground. Lean the machine
down gently with the front surface facing the
ground. Take off the drain hose from the cabinet.
Take the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove
along the side of the spin tub in the order
of (1)~(3), heading for the side of the
spin tub. (See to Figure 3).
Embed the drain hose into the
groove with hands. Take care not
to damage the drain hose in
fastening the fixing clamp.
Install the water inlet hose; Select the water level
Insert the water inlet hose into the water-filling
entrance on the control panel
To dismantle the water inlet pipe,
just push the control handle as indicated in the
figure and pull it out
Select water level according to the
quantity of the laundries.
Set the water level adjusting lever
to needed line.
Attention:The appliance is to be connected to the water
mains using new hose-sets and that old hose-sets should not be reused.
Back
Front
Soft item
Extend to the
Embed into the
spin tub side
groove in turn
Water level
indicator
Maximum
Max
Med
Medium
Min
Minimum
5
Figure 1
Figure 2
Figure 3
Water inlet hose
Water inlet
Advertisement
Table of Contents
