Table of Contents
Advertisement
1
2
3
4
5
6
7
8
9
Using The Remote Control
The CR2032 lithium battery is already installed in the remote control. Pull out the small
mylar insulation tab as shown in the illustration to begin using the remote control.
To use the remote controller, point the remote control transmitter on the remote control
toward the remote control receiver on the front panel of the main unit and press the desired
button. The effective range of the remote controller is approximately 20 feet. Please note that
bright sunlight or artificial light may interfere with the proper operation of the remote control.
Battery Replacement
When the remote operation becomes weak or intermittent, it is time to replace the remote
control battery. Pull out the battery holder, remove the old battery and install a new CR2032
battery in the holder as shown in the illustration. Slide the holder back into the remote
control.
NOTE: If the battery is installed incorrectly the remote control will not work.
• Make sure that you have removed
the mlar insulation tab from the
remote control.
• Ensure the system is connected to an AC outlet that is always "live".
REMOTE CONTROL
1. Remote Control Transmitter
2. Power Button
3. iPod MENU + Button
4. SKIP
10
5. ENTER Button
6. iPod MENU - Button
7. PLAY / PAUSE
11
8. VIDEO OUT Button
12
9. VOLUME
10. SKIP
13
11. MENU Button
12. 3D SOUND Button
13. VOLUME
8
Button
Button
Button
Button
Button
Advertisement
Table of Contents
