Stitch Selection; Stitch Width, Stitch Length; Procedures - Husqvarna Viking Scandinavia 100 User Manual

Procedures

Stitch Selection

Your machine will sew all the stitches pic-
tured on the front. The stitch is set by turning
the stitch selector – the upper dial. A colored
marker lines up while turning the stitch selec-
tor, showing which stitch is set.
Check that the needle is in its highest position
before you turn the stitch selector.
The lower dial is to ajdust the stitch length.
The stitches are divided into two groups.
Forward motion and trimotion stitches. The
stitch length for the left group, forward motion
stitches, can be varied between 0 and 6 and
the width between 0-5.5.
Recommendations for the suggested stitch
length are given next to the stitches.
When you wish to use one of the stitches 09-
15, the trimotion stitches, you turn the stitch
length dial to the left until it reaches the area
. The stitch length is set for these
stitches. The stitch width can be set between
0-5.5. There are letters between the stitch num-
bers which indicate the most suitable presser
foot for each stitch. The letter is also marked
on the presser foot.
Stitch Width
When you select a stitch the machine auto-
matically sets the best stitch width. By turn-
ing the stitch width dial (placed inside the
stitch selector) you can change the stitch
width. The width is numbered 0-5.5.
By setting the stitch width dial at 2.5 you
can halve the width of the stitches. Most of
the stitches will then get a different look and
you have a selection of "new" stitches.
Stitch Length
Recommendations for the suitable setting are
given next to the forward motion stitches.
Always use the recommended setting to start
with but experiment until you arrive at the
exact setting for the actual work you will be
doing.
13