Download  Print this page

Electrolux E36GC70FSS1 Installation Instructions Manual page 6

30", 36" models
Hide thumbs

Advertisement

EJectdcal
Requirements
120 volt, 60 Hertz, properly grounded branch circuit
protected by a 15 amp circuit breaker or time delay fuse.
Do not use an extension
cord with this cooktop.
Check Operation
Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Grounding
Instructions
iMPORTANT Please read carefully.
For personal
safety, this appliance
must be properly
grounded.
The power cord of this appliance is equipped with a 3-
prong (grounding) plug which mates with a standard 3-
prong grounding wall receptacle (see Figure 7) to
minimize the possibility of electric shock hazard from the
appliance.
The wall receptacle and circuit should be checked by a
qualified electrician to make sure the receptacle is
properly grounded.
Preferred Method
Grounding type
wall receptacle
not, under
any_'_
circumstances,
cut,
I
remove,
or bypass
I
the grounding
)
_rong.
J
Do not touch the burners. They may be hot enough to
cause burns.
.
Install
Burner Caps
This cooktop is equipped with sealed burners as
shown (see Figure 8).
A.
Unpack your burner heads and burner caps.
B.
Place burner head over each gas orifice,
matching the head with the orifice size. Be
careful not to damage
the electrode
while
pJacing the head over the orifice.
Make sure
electrode fits correctly into slot in burner head.
C. Place a burner cap on each burner head,
matching the cap size to the head size. Each
burner cap has an inner locating ring which
centers the cap correctly on the burner head.
D. Be sure that all the burner caps and burner
heads are correctly placed BEFOREusing your
cooktop.
Power supply cord with 3-
prong grounding plug.
Figure 7
Where a standard 2-prong wall receptacle is installed, it
is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded 3-
prong wall receptacle.
Do not, under any circumstances,
cut or remove the
third (ground)
prong from the power cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
Burner
Head
Gas Opening
Figure 8
NOTE: There are no burner adjustments necessary on
this cooktop.

Advertisement

loading

  Also See for Electrolux E36GC70FSS1

This manual is also suitable for:

E30gc70fss1