Important Notes to the InstaJJer
I. Read a llinstructions contained i nthese installation
instructions before installing t hecooktop.
2. Remove a llpacking material before connecting the
electrical supply t othecooktop.
3. Observe allgoverning c odes a ndordinances.
4. Besure to leave t hese instructions withtheconsumer.
5. Only certain cooktop models m ay beinstalled o ver
certain built-in electric o ven models. Approved
cooktops a ndbuilt-inovens a relisted bytheMFG ID
number andproduct code. ( Refer to theInformation
Sheet forthemodel n umbers).
Keep these instructions with your Use and Care Guide for
* Be sure your
by a quaJified
instaJJer or service
or, in their
in the United
to the cooktop
must be shut off whiJe Jine connections
made. Failure to do so could result in serious injury
Install the junction box under the cabinet and run 120/
240 or 120/208 Volt, AC wire from the main circuit
panel. NOTE: DO NOT connect the wire to the circuit
panel at this time.
codes and JocaJordinances.
A 3-wire or 4-wire single phase 120/240 or 120/208
Volt, 60 Hz AC only electrical supply is required on a
separate circuit fused on both sides of the line (time-
delay fuse or circuit breaker is recommended). DO
NOT fuse neutral. The fuse size must not exceed the
circuit rating of the appliance specified on the
A circuit breaker or fuse rated at 50 Amp is
recommended for this appliance.
NOTE: Wire sizes and connections must conform with
the fuse size and rating of the appliance in accordance
with the National Electrical Code ANSI/NFPA No. 70-
latest edition and local codes and ordinances.
cord must not be used
with this appliance.
Such use may resuJt in a fire,
shock, or other personal
The appliance should be connected to the fused
disconnect (or circuit breaker) box through flexible
armored or nonmetallic sheathed cable. The flexible
armored cable extending from this appliance should
be connected directly to the grounded junction box.
The junction box should be located as shown in
Figure 2 with as much slack as possible remaining in
the cable between the box and the appliance, so it
can be moved if servicing is ever necessary.
A suitable strain relief must be provided to attach
the flexible armored cable to the junction box.
Unpack and visually inspect the cooktop.
Be sure the bottle of cleaner conditioner packed in the
literature bag is left where the user can find it easily. It
is important that the ceramic-glass cooktop be
pretreated before use. See Cooktop Cleaning and
section in the Use and Care Guide.
Connect the flexible armored cable that extends from
the surface unit to the junction box using a suitable
strain relief at the point the armored cable enters the
junction box. Then make the electrical connection as
Jeads can resuJt
in a short
FoJJow the connector
This appliance is manufactured with a supply wire and a
frame connected green or bare copper grounding wire.