Advertisement
Available languages
Available languages
3. Models:32" CoilElements Cooktops
1.Place cooktop intocountertop o pening andcenter
unitincutout.
2. Remove a llsurface unitsanddripbowls.
3. Unitclampclown information. Once unitisinstalled in
counter o pening, y oumustclampunitdownasshown
infigure12.
4. Putbackallsurface unitsanddripbowls.
5. Makeelectrical connections asoutlined in "Electrical
Connection" s ection.
Reach d ownthrough surface unitopenings a ndinstall
thefourholddownretainers withscrews a sshown. B e
certain cooking top isfirmlyretained tocounter t op.
Cooktop
spacer
4
Hold down retainer
Burner box
Figure 12
Countertop
4. Prior to tightening
installation screws, exert downward
pressure on burner box to assure flanges on burner
box rest firmly on counter. Tighten all screws evenly.
5. Unit clamp down information.
Once unit is installed in
counter opening, you must clamp unit down as shown
in figure 14.
6. Make electrical connections as outlined in "Electrical
Connection"
Section.
To clamp down, insert bracket with offset side of
angle into slot on each side of unit. The screw should
then be run through bracket and against bottom of
counter. Tighten until draws down.
Cookto_
_
Countertop
Nil.,
Hold down retainer _
screw
JO
Burner box
Figure 14
4. Models:
30" and 36" (36" X 211/2") Coil Elements
Cooktops
- These cooktops are designed to fit various cutout sizes.
The minimum and maximum cutout openings are
shown in figure 1.
- If cooktop is to be used in new installation, use
minimum cutout dimensions in figure 1.
- Attach cooktop to cabinet using wood screws through
holes in vertical walls of burner box.
- If cooktop
is to be installed
as a replacement
in
an existing
countertop
opening
(not exceeding
maximum
cutout
dimensions
as shown
in figure
1), the following
steps must be taken:
1. Insert 4 screws and installation spacers through holes
in vertical walls of burner box (see figure 13).
2. Place cooktop into countertop opening and center
unit in cutout.
3. Tighten each screw finger tight or until spacers are
snug against burner box walls.
Spacer
Screw
Figure 13
Checking
Operation
Refer to the Owner's Guide for operation.
Do not touch cooktop glass or elements.
They may be hot enough to burn.
Model
and
Serial
Number
Location
The serial plate is located under the cooktop or in the
burner box and can be seen by lifting up the main top of
unit.
When ordering parts for or making inquires about your
cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your cooktop.
Before
You Call
for
Service
Read the Avoid Service Checklist and operating
instructions in your Owner's Guide. It may save you time
and expense. The list includes common occurrences that
are not the result of defective workmanship or materials
in this appliance.
Refer to the warranty in your Owner's Guide for our
service phone number and address. Please call or write
if you have inquiries about your product and/or need to
order parts.
7
Advertisement
