ver The
icrowave
ange
Oven
BEFORE
YOU
BEGIN
Read these instructions completely and carefully.
• _
Save these instructions
for local
inspector's use.
• _
Observe all governing codes and
coordinates.
• NOTE TO INSTALLER
- Be sure to leave these
instructions with the Consumer.
• NOTE
TO CONSUMER
- Keep these instructions
for
future reference.
• SKILL
LEVEl.
- Installation of this appliance requires
basic mechanical and electrical skills.
Proper installation is the responsibility
of the installer.
Product failure due to improper
installation is not covered
under the Warranty.
Please
read all instructions
thoroughly
before installing
the Over the Range Microwave
Oven. Two people are
recommended
to install this product.
If a new electrical
outlet is required, its installation should
be completed by a qualified electrician before the Over the
Range Microwave
Oven is installed.
See 3 ELECTRICAL
GROUNDING INSTRUCTIONS
on page 2.
1 MOUNTING SPACE
This Over the Range Microwave Oven requires a mounting
space on a wall as shown in Figure 1. It is designed to be used
with standard 12" walt cabinets.
...................
i
__i
30" or more
fromcooking
surface
66" or more
fromfloor
2 WALL CONSTRUCTION
This Over the Range Microwave Oven should be mounted
against and supported by a flat vertical walt. The wall must be
flat for proper installation. If the wall is not flat, use spacers to
fill in the gaps. Wall construction
should be a minimum of 2" x
4" wood studding and 3/8"or more thick dry wall or plaster/lath.
The mounting surfaces must be capable of supporting weight
of 110 pounds--the
oven and contents--AND
the weight of
all items which would normally be stored in the top cabinet
above the unit.
The unit should be attached to a minimum
of one 2" x 4"
wall stud.
To find the location of the studs, one of the following methods
may be used:
A. Use a stud finder, a magnetic device which locates the
nails in the stud.
B. Use a hammer to tap lightly across the mounting surface
to find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with
a small nail to find the edges of the stud and then placing a
mark halfway between the edges. The center of any adjacent
studs will normally be 16" or 24" to either side of this mark.
NEEDHELP?
For toll-free telephone support in the U.S. and Canada:
1-877-4ELECTROLUX
(1-877-435-3287)
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
P/H316495050
TIlISEB177WRRZ-EL81
Printed in Thailand