Download Print this page
Frigidaire FEF316BSD Installation Instructions
Frigidaire FEF316BSD Installation Instructions

Frigidaire FEF316BSD Installation Instructions

30" electric range
Hide thumbs Also See for FEF316BSD:

Advertisement

INSTALLATION
AND SERVICE
MUST BE PERFORMED
BYA QUALIFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL
ELECTRICAL
INSPECTOR'S
USE.
READ AND SAVE THESE INSTRUCTIONS
FOR FUTURE
REFERENCE.
Clearances
and Dimensions
1.
Provide adequate clearances between the range and adjacent combustible surfaces.
2.
Location--Check
location where the range will be installed. Check for proper electrical supply, and the stability
of the floor.
3.
Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must
be solid and level.
..................
Minimum to
wall on either
1"$
to
side of range
above 36" height.
iiiiiiii
i
_® _
®®]18
eitherside
I
/
i_
of range.
_
30" _
SIDE
VIEW
I_13"_'1
Maximum
depth
r-
for cabinets
[F
above range top.
O' clearance below cooking l_p and at rear of range.
RANGE
OVERALL
DIMENSIONS
253/4 '
445/8"
Door Open
,,_"_
\
29 7/8
_ _ _
Centerline
of range
2-5/8" for models equipped
with warmer drawers"
3-1/2" for models equipped
with storage drawers
Wall
Edge
*30" MINIMUM
CLEARANCE
BETWEEN
THE TOP OF THE COOKING
SURFACE
AND THE
BOTTOM
OF AN
UNPROTECTED
WOOD OR METAL CABINET; OR 24" MINIMUM WHEN BOTTOM OF WOOD OR METAL CABINET IS
PROTECTED
BY NOT LESS THAN 1/4" FLAME RETARDANT
MiLLBOARD COVERED WITH NOT LESS THAN NO. 28
MSG SHEET STEEL, 0.015" STAINLESS
STEEL, 0.024" ALUMINUM
OR 0.020" COPPER.
0" CLEARANCE
IS THE
MINIMUM FOR THE REAR OF THE RANGE. FOLLOW ALL DIMENSION
REQUIREMENTS
PROVIDED ABOVE TO
PREVENT PROPERTY DAMAGE, POTENTIAL FIRE HAZARD, AND INCORRECT COUNTERTOP AND CABINET CUTS.
TO ELIMINATE THE RISK OF BURNS OR FIRE BY REACHING OVER HEATED SURFACE UNITS, CABINET STORAGE
SPACE
LOCATED
ABOVE THE SURFACE
UNITS SHOULD
BE AVOIDED.
IF CABINET
STORAGE
IS TO BE
PROVIDED, THE RISK CAN BE REDUCED BY INSTALLING A RANGE HOOD THAT PROJECTS HORIZONTALLY
A
MINIMUM OF 5" BEYOND THE BOTTOM OF THE CABINETS.
PIN 316259200 REV B (0211)
1
EspaSol - P_ginas 5-8

Advertisement

loading

Summary of Contents for Frigidaire FEF316BSD

  • Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BYA QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. Clearances and Dimensions Provide adequate clearances between the range and adjacent combustible surfaces. Location--Check location where the range will be installed. Check for proper electrical supply, and the stability of the floor.
  • Page 2 NORMAL INSTALLATION STEPS IMPORTANT SAFETY INSTRUCTIONS Anti-Tip Bracket Installation Instructions- Important Ifthe information in this manual is not followed SafetyWarning exactly, a fire or electrical shock may result causing property To reduce the risk of tipping of the range, the range must damage, personal injury or death.
  • Page 3 C. Level and Position Range Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearance 1/8" is required between the bottom of the range and the Cover leveling leg to allow (17mm) room for the bracket. Use a spirit level to of Range Range Side _...
  • Page 4 3-Wire 4-Wire Connection Connection Terminal Terminal Insulated Copper Ground Wire 4-Wire Copper Power Supply Cord. 3-Wire Copper Power Supply Cord. To Fused Disconnect Box or Approved To Fused Disconnect Box or Approved Wiring Device for Copper Supply Cord. Wiring Device for Copper Supply Cord. 4.

This manual is also suitable for:

Fef351cwaFef351cuaFef316bscFef351csaFefl89ccaFef357bse ... Show all