Download Print this page

Frigidaire ATF7000ES1 Installation Instructions Manual

Full size tumble action washers
Hide thumbs Also See for ATF7000ES1:

Advertisement

Full Size Tumble
Action
Washers
Before
beginning
installation,
carefully
read these instructions.
This will simplify
the
instaffation
and ensure the washer is installed correctly and safely. Leave these instructions
near the washer after installation
for future reference.
NOTE: The electrical
service
to the washer
must conform
with
local codes and ordinances
and the latest
edition
of the National
Electrical
Code, ANSI/NFPA
70.
For your safety the information
in
this manual must be followed to minimize the risk
of fire or explosion or to prevent property damage,
personal injury or loss of life.
- Do not store or use gasoline or other flammable
vapors and liquid in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS
. Do not try to light any appliance.
. Do not touch any eIectrica[ switch; do not
use any phone in your building.
. Clear the room, building
or area of all
occupants.
. immediately
call your gas supplier from a
neighbor's phone. Follow the gas suppliers
instructions.
. if you cannot reach your gas supplier, call
the fire department.
installation
and service must be performed
by a
qualified
installer,
service agency
or the gas
supplier.
Printed in U.S.A.
Contents
SUBJECT
PAGE
Preqnstallation Requirements
2
Electrical Requirements
2
Grounding Requirements
2
Water Supply Requirements
2
Drain Requirements
2
Roughqn Dimensions
3
Location Of Your Washer
4
Unpacking
4
Installation
5-6
Replacement Parts
6
P/N 134602900A (0512)

Advertisement

loading

Summary of Contents for Frigidaire ATF7000ES1

  • Page 1 Full Size Tumble Action Washers Before beginning installation, carefully read these instructions. This will simplify instaffation and ensure the washer is installed correctly and safely. Leave these instructions near the washer after installation for future reference. NOTE: The electrical service to the washer must conform with...
  • Page 2 absence of local codes, with tile National Electrical PRE-INSTALLATION REQUIREMENTS Codes, ANS!/NFPA 70 (latest edition). If in doubt, call a licensed electrician. DO NOTcut off or alter Tools Required for Installation: the grounding prong on the power supply cord. In 1.
  • Page 3 ROUGH-_N D_MENS_ONS 23¾" 24" (60.33) (60.96) 22" 25/8" (55.88) 35/8" (6.67) (9.21) 255/8" (65.09) 281/4" inches(¢m} (71.76) NOTE: For _edesta{ installations, see additional installation instructions included with the pedestal. For stackinei installations, see additional installtion instructions included with the stacking kit.
  • Page 4 LOCATION OF YOUR WASHER DO NOT INSTALL YOUR WASHER: In an area exposed to dripping water or outside weather Carefully return the washer to an upright position. conditions. The ambient temperature should never be below 60 ° F (15.6 ° C) for proper washer (deterg entbreakd°wn) Carefully move the washer to within 4 feet (122cm) of the operation.
  • Page 5 INSTALLATION STOP DRAIN HOSE TABS Zeve//ng the Washer Excessive noise and vibration can be prevented by properly leveling the washer. SPRING CLAMP For free standing installation and with the washer in it's PROVIDED final position, place a level on top of the washer. Adjust ON HOSE the leveling legs so the washer is level fronbto-rear side4o-side, and stable corner-to-cornen...
  • Page 6 PARTS If replacements parts are needed for your washer, contact tile source where you purchased your washer, call 1-800-944-9044, or visit our website, www.frigidaire.com, for the Frigidaire Company Authorized Parts Distributor nearest you. Destroy the carton and plastic bags after the washer is unpacked.

This manual is also suitable for:

Atfb7000ep0Atf6000es1Atf7000es0Atf6000es0Atf7000ep0Atfb7000es1 ... Show all