General Installation - Frigidaire FAQE7021LB0 Installation Manual

General installation
1 Connect the exhaust duct to the outside exhaust
system (see pages 6 through 8). Use of a 4" (102
mm) clamp (item A) is recommended to connect
the dryer to the exhaust vent system. Use metal
foil tape to seal all other joints.
2 Carefully slide the dryer to its final position. Adjust
one or more of the legs until the dryer is resting
solidly on all four legs. Place a level on top of the
dryer. The dryer MUST be level and resting solidly
on all four legs. Rock alternating corners to check
for stability, Remove and discard door tape,
Be sure the power is off at a circuit breaker/fuse box
before plugging the power cord into an outlet,
3 Plug the power cord into a grounded outlet,
4 Turn on the power at the circuit breaker/fuse box.
5 Read the Use & Care Guide provided with the dryer.
It contains valuable and helpful information that
will save you time and money.
6 If you have any questions during initial operation,
please review the "Avoid Service Checklist" in your
Use & Care Guide before calling for service.
7 Place these instructions in a location near the dryer
for future reference.
A wiring diagram and technical data sheet are located
inside the dryer console.
Do not, under
any circumstances,
cut, remove,
or bypass the
grounding prong.