Download Print this page

Placement Of Mounting Plate; Removing The Mountirlg Plate; Finding - Frigidaire CFMV157GSA Installation Instructions Manual

Over the range
Hide thumbs

Advertisement

Installation
Instructions
PLACEMENT OF THE MOUNTING
PLATE
I-_
REMOVING
THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING
THE MOUNTING
PLATE
[]Remove
the installation
instructions,
filters,
glass
tray and the small hardware
bag. Do not remove
the Styrofoam
protecting
the fl'ont of the oven.
[]Fold
back all 4 carton
flaps fully against
carton
sides. Then
carefully
roll the oven and
carton
over
onto
the top side. The
oven should
be resting
in
the Styrofoam.
[Pull
the carton
up and
off the oven.
[]Remove
and
properly
discard
plastic
bags.
Screws----__
Mounting
Plate
T
i
[]Remove
the screws from
the mounting
plate.
This plate
will be used as the rear
wall template
and
for mounting.
Reinstall
the screws into the
holes
where
they were removed.
I-_
FINDING
THE WALL STUDS
]Find
the studs,
using
one of the following
methods:
A.
Stud finder
- a magnetic
device
which
locates
nails.
OR
B. Use a hammer
to tap lightly across the
mounting
surface to find a solid sound.
This will indicate
a stud location.
[]
After locating the stud(s), find the center by
probing
the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent
studs should
be 16" (40.6 cm) or 24" (61 cm) fi'oln this mark.
[]Draw
a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED
TO
AT LEAST ONE WALL STUD.
8

Advertisement

loading

  Also See for Frigidaire CFMV157GSA