Mount The Microwave Oven - Frigidaire CFMV157GSA Installation Instructions Manual

Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR
RECIRCULATION (cont.)
[]Place the blower unit back into the opening.
CAUTION: Do
not pull or stretch the blower unit
wiring. Make sure the wires are not pinched, and
that they are properly secured.
[]Secure blower unit to microwave with the screw
removed in Step 4. Make sure the screw is tight.
[]Replace blower plate with the screw removed in
Step 1. Make sure the screw is tight.
g
I
_ Backof
_ _- Microwave
MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of tile cord.
NOTE: We
recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If
filler blocks are not used,
case damage may occur from overtightening
screws.
NOTE:
When mounting the
nlicrowave oven, thread
power cord through hole in
bottom of top cabinet. Kee t)
it tight throughout Steps
1 3. Do not pinch cord or
lift oven by pulling cord.
[]Lift microwave, tilt
it forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
[]Rotate fl'ont of oven
up against cabinet
bottom.
[]Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Equivalentto Depth
of CabinetRecess
Self-AligningScrew
MicrowaveOvenTop
[]Attach the microwave oven to the top cabinet.
21