Download Print this page

Attach Mounting Plate To Wall; Preparation Of Top Cabinet; Adapting Microwave Blower For Outsme Back Exhaust - Frigidaire CFMV157GSA Installation Instructions Manual

Over the range
Hide thumbs

Advertisement

Installation
Instructions
I-_
ATTACH THE MOUNTING
PLATE TO THE WALL
Attach
the plate
to the wall using
toggle
bolts.
At least one wood
screw must
be used to attach
the plate
to a wall stud.
[]Remove
the toggle
wings
fl'om the bolts.
[]Insert
the bolts
into the mounting
plate
through
the holes
designated
to go into drywall
and
reattach
the toggle
wings
to 3/4" (19 ram)
onto
each bolt.
To use toggle
bolts:
Mounting
Plate
Spacing for TogglesMore
+l_,--,.[_Than
Wall Thickness
toggleWings
Wa, !_
Bolt End
[]Place
the mounting
plate
against
the wall and
insert
the toggle
wings into the holes
in the wall
to mount
the plate.
NOTE:
Before
tightening
toggle
bolts and wood
screw, make
sure the tabs on the mounting
plate
touch
the bottom
of the cabinet
when
pushed
flush
against
the wall and that the plate
is properly
centered
under
the cabinet.
CAUTION:
Be careful
to avoid pinching
fingers
between
the back of the mounting
plate
and the wall.
[]Tighten
all bolts.
Pull the plate
away fi'om
the wall
to hel t) tighten
the bolts.
I-_
USE TOP CABINET TEMPLATE
FOR PREPARATION
OF TOP
CABINET
You need
to drill holes
for the top support
screws and
a hole large
enough
for the power
cord
to fit through.
• Read the instructions
on the TOP CABINET
TEMPLATE.
• Tape it underneath
the top cabinet.
• Drill the holes, following the instructions
on the
TOP CABINET TEMPLATE.
CAUTION:
Weal" safety goggles
when
drilling
holes
in the cabinet
bottom.
ADAPTING
MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
[]
Remove
and
that holds
blower
motor
save screw
to microwave.
BlowerMotor
Backof
""
BlowerMotor
"_
Screw
[]
Carefully
the blower
unit.
The wires
pull out
will extend
far enough
to allow you to adjust
the blower
ui°lit.
EndA
16

Advertisement

loading

  Also See for Frigidaire CFMV157GSA