GE GTDS820ED0WS Installation Instructions Manual page 8

Installation Instructions
E_ BATHROOM OR BEDROOM INSTALLATION
• The drger lUST be vented to the outdoors. See EXHAUST
INFORMATIONsection 3 & 4.
• The installation must conform with local codes or, in the absence
of local codes, with the
NATIONAL ELECTRICAL CODE, ANSI/NFPA NO. 70.
[] MOBILE OR MANUFACTURED HOME
INSTALLATION
• Installation must conform to the MANUFACTURED HOMECONS-
TRUCTION & SAFETY STANDARD, TITLE 24, PART32-80 or, when such
standard is not applicable, with AMERICANNATIONAL STANDARD
FORMOBILEHOME,ANSI/NFPANO.50lB.
• The drger MUSTbe vented to the outdoors with the termination
securelg fastened to the mobile home structure.
(See EXHAUSTINFORMATIONsection 3 &4).
• The vent lUST NOT be terminated beneath a mobile or manu-
factured home.
• The vent duct material MUSTBE METAL.
• Do not use sheet metal screws or other fastening devices which
extend into the interior of the exhaust vent.
• See section 2 for electrical connection information.
• Kit 14-D346-33 HUST be used to attach the drger securelg to the
structure.
• The vent must not be connected to ang other duct, vent or chimneg.
[] GARAGE INSTALLATION
(IFALLOWEDBYLOCALCODES)
° Dryers installed in garages must be elevated 18 in. (46cm)
above the floon
[] DRYER EXHAUST TO RIGHT, LEFT OR
BOTTOM CABINET
,AWAR I G
Disconnectdryer from electrical supply.
Wear gloves and arm guards.
Closethe backopeningwith coverplate (KitWE1 M 454}.
Electrical S hock Failureto do so may result in electrical shock
Hazard or
lacerations.
The internal elbow must be included in the total elbow count.
Seeexhaust information)
REMOVE
SCREW
AND SAVE
REMOVE
DESIRED
KNOCKOUT
(ONE ON_)
Detach and remove the bottom, right or left side knockout
as desired. Remove the screw inside the drger exhaust duct
and save. Pull the duct out of the drger. F_XlNG HOLE
B _ A
Cut the duct 1_
as shown and keep portion A. !4"
TAB LOCATION
BENDTAB
UP45°
I
I
Through the rear opening, locate the tab in the middle of
the appliance bose. Lift the tub to about 450 using a flat
blade screwdriver.
ADDING NEW DUCT
FIXING
HOLE
PORTION "A"
RIGHTOR
LEFT SIDE
EXHAUST
Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Use the screw saved previouslg to secure
the duct in place through the tab on the appliance base.
NOTE: the long vent model (GTDL740EDWW} is capable of
right side, rear and bottom venting onlg.