GE GTDS820ED0WS Installation Instructions Manual page 15

Installation Instructions
REVERSING THE DOOR SWING
GLASS PANEL DOOR MODELS:
I!
GTDS810EDOWS
GTDS810GDOWS
GTDS815EDOMC
GTDS815GD01VlC
GTDS820EDOWS
GTDS820GDOWS
GTDS825EDOMC
GTDS825GD01VlC
GHDS830EDOWS
GHDS830GDOWS
GHDS835ED0iVlC
GHDS835GDOMC
GTDS850EDOWS
GTDS850GDOWS
GTDS855ED0iVlC
GTDS855GDOMC
GTDS860EDOWS
GTDS860GDOWS
GTDS865ED0iVlC
GTDS865GDOMC
Open the door to approximatelg 170 degrees.
With (] puttg knife, remove the 4 plastic covers located
(]long the left side of front panel and set them (]side.
Plastic Cop (4)
front panel
_ Remove the bottom screw from each hinge (right side)
and p(]rti(]llg insert them into the top left side hinge
holes.
NOTE:All 4 front panel hinge screws will now be in the
top hinge holes - 2 on the left and 2 on the right.
_ Loosen the bottom 2 right side hinge screws. Remove the
door and place it on (] protected fiat surface to (]void (]ng
damage.
Remove both the Blind Plate and the Strike Plate and
install them in opposite positions.
Strike plate
_ Remove the 4 door hinge screws, 4 edge screws, and
8 inside screws. Lift the inner door upwards using (] fiat
blade screwdriver.
Inside screws
Edge
!5