GE GTDS820ED0WS Installation Instructions Manual page 12

Installation Instructions
_ Remove and swap the 2 cover caps and door handle
from the outer door:
A. Squeeze the tabs on the inside of the door handle
clips. Push clips through the outer door.
B.Squeeze the tabs on the inside of the cover caps.
Push caps through the outer door.
Inside of door
Door ha_{dle
Door hc
C. Push the door handle clips into the openings on the
opposite side of the outer door making sure you flip
the handle so it curves to the inside.
D. Push the cover caps into the openings on the outer
door where the handle was removed.
Inside of door
Coverca
Door handle
_When the cover caps and door handle in place, mount
the inner door back into the outer door with the screws
removed in step 4. Make sure you mount the hinges on
the side opposite the handle.
I
I
Inside screws
Door hinge
screws
screws
-Handle
_ iVlount the assembled door on the 2 upper left side hinge
screws installed in step 2,
Move the hinge screws loosened in step 3 into the lower
left side screw holes and firmly tight all 4 screws
Door
_r and
_- tighten screws
_ Install the 4 plastic caps removed in step ! into the 4
right side front panel holes.
NOTE:To return the door to the original setup, follow
these instructions, swapping "left" and "right".
12