GE GTDS820ED0WS Installation Instructions Manual page 11

Installation Instructions
ABOUT REVERSING THE DOOR
SWING
IMPORTANT NOTES:
• Reod the instructions oil the wou through before storting.
• Hondle ports corefully to ovoid scrotching point.
•Set screws down by their reloted ports to ovoid using them in
the wrong ploces.
• Provide o non-scrotching work surfoce for the door. • Normol
completion time to reverse the door swing is :30-60 minutes.
IMPORTANT:
Once you begin, do not move the cobinet until door-swing
reversol is completed. These instructions ore for chon- ging
the hinges from the right side to the left side - if you ever
wont to switch them buck to the right side, follow these some
instructions ond reverse oll references to the left ond right.
Tools Needed
[] Stondord #2 Phillips Screwdriver
[] Tope-tipped puttg knife
[] Smull flut blude screwdriver
Before you start
Unplug the drger from its
electricol outlet
REVERSING THE DOOR
SWING
SOLID DOOR MODELS:
GTDP740EDOWW
GTDP740G DOWW
GTDL740EDOWW
GTDL740GDOWW
H Open the door to opproximotely 170 degrees.
With u putty knife, remove the 4 plostic cops Iocoted
olong the left side of front ponel ond set them oside.
Plostic Cop (4)
Ill /
11
_ Remove the bottom screw from eoch hinge (right side)
ond portiolly insert them into the top left side hinge holes.
NOTE:All 4 front punel hinge screws will now be in the
top hinge holes - 2 on the left ond 2 on the right.
_ Loosen the bottom 2 right side hinge screws. Remove
the door und place it on o protected riot surfoce to ovoid
uny domuge. Remove both the Blind PIote und the Strike
Plute und instoll them in opposite positions.
Strike plote
_ Remove the 4 door hinge screws, 8 edge screws, ond 4
inside screws. Lift the inner door upwords using o riot
blode screwdriver.
screws
I_ Edge screws
Inside screws
_-_ Edge screws
Door hinge
screws