Preparing The Opening - GE PGP953 Installation Instructions Manual

Installation Instructions
PREPARING THE OPENING
r_ MAINTAIN THE FOLLOWING
MINIMUM CLEARANCE DIMENSIONS
13" MAX. Depth
of unprotected
overhead
cabinets
R - IV]IN,
clearance from
cutout to right
side wall
I
30" MIN. clearance from
countertop to unprotected
overhead surface
I
C - MIN, I
clearance from I
cutout to rear
wall
L - MIN. clearance
from cutout to left
side wall 30" or wider
cabinet base
2-1/2" MIN from cutout to
front of counterto u
L R C
PGP953
3-3/4"
6" 2-i/4"
PGP959 12" 12" 2-718"
CGP350 12" 12" 2-7/8"
ALL HORIZONTAL CLEARANCES MUST BE MAINTAINED
FOR A MINIMUM OF 18" ABOVE THE COOKING SURFACE.
18" MIN. height
countertop
to nearest
cabinet on either
side of unit
NOTE: Allow 7/16"
minimum vertical
clearance from the
cooktop bottom (or
3-11/16" minimum depth
from the countertop) to
any combustible surfaces,
such as a cabinet drawer.
For island installation, maintain
2-1/2 in. minimum from cutout to front and back
edge of countertop. Maintain 3 in. minimum from
cutout to side edges of countertop.
I_ OVERALL COOKTOP DIMENSIONS
30" _i _ 21"
_-- v 28-1J4"
19-3/8" _1 /
F31 CUTOUT DIMENSIONSOF COUNTERTOP
To ensure accuracy, it is best to make a template
when cuttinq the openinq in the counter.
/8" width cut
I_ RECOMMENDED GAS SUPPLY
LOCATION FROM BACKWALL
r' Min. From Backwall
Recommended
gas supply
location
From Cutout
Center Line
r_ MAKE SURE WALL COVERINGS,
COUNTERTOP AND CABINETS
AROUND COOKTOP CAN
WITHSTAND HEAT (UP TO 200°F)
GENERATED BY COOKTOP
Wallcovering,
cabinets and
countertop mustl
withstand heat I
F61 FOR AMERICANS WITH
DISABILITIES ACT (ADA) FORWARD
APPROACH INSTALLATION ONLY:
Allow 5" minimum depth
between the countertop
and an enclosure.
NOTE: The enclosure must
be made of wood material.
Also, an access panel is
required for the electrical
outlet, pressure regulator,
shut-off valve, hold-down
brackets, and service.
l
ii
]J