Electrical Preparation - Bosch SHV46C13UC/38 Installation Instructions Manual

30" i
(762mm)
21 "
(533mm)
Figure 4
Dishwasher Electrical Rating
Volts Hertz Amperes Watts
1,450
120 60 12
(max)
3/8"- 1/2"
(10mm - 13mm)
Figure 5
Electrical Preparation
. ELECTRICAL PREPARATION
Avoid E(ectrica( Shock Hazard
Do not work on an energized circuit. Doing
so could result in serious injury or death.
Only qualified electricians should perform
electrical work. Do not attempt any work on the
dishwasher electric supply circuit until you are
certain the circuit is de=energized.
Avoid Fire Hazard
Make sure electrical work is properly instal(ed.
Only qualified electricians should perform
electrical work.
Electrical Supply
The customer has the responsibility of ensuring that the
dishwasher electrical instal(ation is in compliance with
al( national and (ocal electrical codes and ordinances.
The dishwasher is designed for an electrical supply of
120V, 60 Hz, AC, connected to a dishwasher-dedicated,
properly grounded electrical circuit with a fuse or breaker
rated for 15 amps. Electrical supply conductors shal( be
a minimum #14 AWG copper wire rated at 75°C (167°F)
or higher.
Regardless of where the electrical supply cable enters
the enclosure, position the cable 21" (533mm) from the
enclosure's left side, as shown in Figure 4. Extend the
cable 30" (762mm) from the enclosure's back, as shown
in Figure 4.
Remove 3" - 4" (76mm - 102mm) of the cable's outer
casing, as shown in Figure 5, then remove 3/8"- 1/2"
(10 - 13mm) of insulation from each wire, as shown in
Figure 5.
6