Yamaha V-Star XVS1100R Owner's Manual page 85

1. Quick fastener (× 3)
If a fuse is blown, replace it as follows.
NOTE:
_
Include steps 1–3 and 9–10 only for the
main fuse.
_
1. Remove the rider seat. (See
page 3-11 [XVS1100] or 3-13
[XVS1100A] for rider seat removal
and installation procedures.)
2. Remove the quick
shown by pushing the center in
with a screwdriver, then pulling the
fastener out.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Ignitor unit panel
2. Spare main fuse
3. Main fuse
3. Pull the ignitor unit panel outward
to the right.
4. Turn the key to "OFF" and turn off
the electrical circuit in question.
5. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
fasteners
Specified fuses:
Main fuse:
Backup fuse (odometer):
Ignition fuse:
Headlight fuse:
Carburetor heater fuse:
Signaling system fuse:
CAUTION:
_
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
_
6. Turn the key to "ON" and turn on
7. If the fuse immediately blows
8. Install the storage compartment
30 A
5 A
10 A
15 A
15 A
10 A
6-30
the electrical circuit in question to
check if the device operates.
again, have a Yamaha dealer
check the electrical system.
cover.
EC000103
6