Related Manuals for HomeKing HHG610SS
Summary of Contents for HomeKing HHG610SS
- Page 4 The adjacent furniture and all materials used in installation able withstand minimum temperature of 85°C above the ambient temperature of the room it is located in, whilst in use.
- Page 6 Before attempting to clean the appliance, it should be disconnected from the mains and cool.
- Page 11 You should clean the hob surface (see “Cleaning and maintenance” section). The appliance is fitted with a flame failure safety device on each burner, which is designed to stop the flow of gas to the burner head in the event of the flame going out.
- Page 12 Always place pans centrally over the hob burners and position them so that the handles cannot get accidentally caught or knocked off. You should also make sure that the handle is not over one of the other hob burner flames.
- Page 13 Make sure that the hob surface, pan stands and hob burners have cooled before you attempt to touch them.
- Page 14 Make sure that you reassemble the burners in the original way.
- Page 15 The appliance must not be installed in a bathroom or shower room.
- Page 17 You must have a gap of at least 25 mm between the underneath of the appliance and any surface that is below it.
- Page 18 Do not use a silicon sealant to seal the appliance against the aperture. This will make it difficult to remove the hob from the aperture in future, particularly if it needs to be serviced.
- Page 20 The female coupler must be positioned the right way up, as shown in the picture above.
- Page 22 The minimum flow adjustment process must be completed before the appliance is next used.
Need help?
Do you have a question about the HHG610SS and is the answer not in the manual?
Questions and answers