Download  Print this page

Drain Requirements; Water Supply Requirements; Electrical Requirements - Kenmore 66512723K310 Installation Instructions Manual

Plastic tub undercounter dishwasher
Hide thumbs

Advertisement

Table of Contents
Drain Requirement
A new drain hose is supplied with your dishwasher. If drain
hose is not long enough, use a new drain hose with a
maximum length of 12 ft (3.7 m) (Part Number 3385556)
that meets all current AHAM/IAPMO
test standards, is
resistant to heat and detergent, and fits the 1" (2.5 cm) drain_
connector of the dishwasher.
Make
sure to connect drain
hose to waste tee or disposer
inlet above drain trap in house plumbing
and 20" (50.8 cm)
minimum
above
the floor. It is recommended
that the drain
hose either be Jooped up and securely fastened
to the
underside
of the counter, or be connected
to an air gap.
Make sure to use an air gap if the drain hose is _onnected to
house plumbing lower than 20" (50.8 cm) above subfloor or
floor.
Use 1.,_,, m inimum I.D. drain line fittings.
If required, the air gap should be installed in accordance
with the air gap installation instructions. When you are
connecting the air gap, a rubber hose (not provided) will be
needed to connect to the waste tee or disposer inlet.
Water Supply Requirements
A hot water line with 20 to 120 psi (138 to 862 kPa) water
pressure can be verified by a licensed plumber.
12001:(49°C) water at dishwasher.
3/8" O.D. copper tubing with compression fitting or flexible
braided water supply line (Part Number 4396897RP).
NOTE. 1/2" minimum plastic tubing is not recommended.
A 90 ° elbow with 3A" hose connection with rubber washer.
Do not solder within 6" (15.2 cm) of the water inlet valve.
Electrical Requirernents
Be sure that the electrical connection and wire size are
adequate and in conformance
with the National Electrical
Code, ANSI/N1:PA 70 - latest edition and all local codes and
ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
You must have.
120-volt,.60 Hz, AC-only, 15- or 20-amp, fused electrical
supply.
Copper wire only.
We recommend..
A time-delay fuse or circuit breaker.
A separate circuit.
If connecting dishwasher
with a
power supply cord:
Use UL Listed power supply cord kit
(Part Number 4317824)
marked for
use with dishwasher.
Power supply cord must plug into a grounded
3 prong outlet, located in the cabinet next to
the dishwasher opening. Outlet must meet all
local codes and ordinances.
If connecting dishwasher
with direct wiring:
Use flexible, armored or
nonmetallic sheathed, copper wire
with grounding wire that meets the
wiring requirements for your home
and local codes and ordinances.
Use a UL Listed/CSA Approved strain relief.
6

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Kenmore 66512723K310