Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Plug into a grounded 3 prong outlet. Check that power supply
cord does not touch dishwasher motor or lower part of
Read the Dishwasher User Instructionsthat came with your
Check that all parts have been installed and no steps were
skipped. Check that you have all tools used.
Start dishwasher and allow it to complete the shortest wash
cycle. After the first 2 minutes, unlatch door, wait 5 seconds,
then open door. Check that there is water in the bottom of
the dishwasher tub. Check that dishwasher is working
If the dishwasher is not working properly, disconnect power or
unplug dishwasher and see "If Dishwasher Does Not Operate"
If Dishwasher Does Not Operate
First try the solutions suggested here to possibly avoid the cost
of a service call.
Has the circuit breaker tripped or the house fuse blown_
Is the door closed tightly and latched?
Has the cycle been set correctly to start the dishwasher?
Is the water turned on?
If none of these possible solutionswork, call 1-800-4-MY-HOME
Congratulations on purchasing your water
and energy efficient dishwasher! This
dishwasher cleans by spraying the dishes
with water and pauses to allow the
detergent to soak into and release the soils
on the dishes. The cycles are longer due to
the soak and the pauses for exceptional
cleaning. Models with SmartWash ®HE
contain an optical water sensor.The optical
water sensor is used to determine the optimum water and
energy consumption for great cleaning performance. The first
cycle using the sensorwill run longer to calibrate the optical
Rinse Aid is necessary for good drying results:
This dishwasher is designed to be used with rinse aid for good
drying performance and controlling the buildup of hard water
deposits. Energy efficient dishwashers use less water and
energy, so they depend on the water sheeting action of rinse aid
for good drying performance.
Start/Resume light may flash:
When pressing Start/Resume, you must make sure the door is
closed within 3 seconds. If you do not close the door within
3 seconds, the Start/Resume light will flash until you press it
again. (You must also do this when adding a dish during the
middle of a cycle.)
NOTE. If a braided supply hose is used, replace inlet hose after
5 years to reduce the risk of hose failure. Record hose
installation or replacement dates on the hose for future