Table of Contents
Advertisement
Available languages
Available languages
Push bracket into slot on the side of dishwasher, and bend tab in
toward the side of the dishwasher so that it keeps the bracket in
place. Repeat this step for the other side of the dishwasher.
NOTE: Do not attach the dishwasher. This will be done later.
Prepare Water $uppty Line
Copper tubing only: Slide nut, then ferrule, about 1" (2.5 cm)
onto copper tubing.
NOTE: To avoid vibration
during operation,
route the water
supply line so that it does not touch the dishwasher base, frame
or motor.
Connect the %" compression fitting to the water supply line
prior to installing the unit into the cabinet opening. Attach such
that the _" connection is facing upward
as shown above.
Copper tubing only: Put the tubing into the 90 ° elbow fitting as
far as it will go (the copper tubing bends and kinks easily). Slide
the nut and ferrule forward
and start the nut onto the elbow
threads.
Flexible braided connection: Secure nut to elbow using _" open
ended wrench or adjustable
wrench.
NOTE: Do not use Teflon et tape with compression fittings.
Move Dishwasher
Close to Cabinet Opening
I
Excessive Weight Hazard
J
r
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
NOTE: Do not install kick plate until instructed to do so
IMPORTANT: Double-check
correct placement of utilities. Grasp
the sides of the dishwasher at the edges of the door panel.
Move dishwasher close to cabinet opening.
NOTE: Do not push on the front Of the panel or on the console.
Panel or console may dent.
Helpful Tip: Temporarily
tape utilities to the floor in the locations
shown to prohibit them from moving when dishwasher is moved
into the cabinet opening.
Check that water line is on the left side of opening and drain
hose is near the center of the cabinet opening.
"I'®TEFLON is a registered trademark
of E.I. Du Pont De Nemours and Company.
Page 16
Hide quick links:
Advertisement
Chapters
Table of Contents
