Move Dishwasher Close To Cabinet Opening; Break End Of Bracket; Remove Plastic Buttons; Install Bracket - Kenmore 66513292K115 Installation Instructions Manual

Stainless steel tub undercounter dishwasher
Table of Contents


Option B, Side Attachment
For marble,
granite, or other hard surface countertops
NOTE: Remove the brackets from the parts package.
Score JJne
Break off the end of the bracket along the scored line.
With another person holding the rear of the dishwasher to keep
it from tipping, open dishwasher door and place towel over
pump assembly and spray arm of dishwasher. This will keep
screws from falling into pump area when you are securing
dishwasher to cabinet.
Push the plastic buttons out of the side of the tub.
NOTE: Save the buttons to cover the holes after dishwasher is
Push bracket into slot on the side of dishwasher, and bend tab in
toward the side of the dishwasher so that it keeps the bracket in
place. Repeat this step for the other side of the dishwasher.
NOTE= Do not attach the dishwasher. This will be done later.
Excessive Weight Hazard
Use two or more people to move and install
Failure to do so can result in back or other injury.
NOTE: Do not install kick plate until instructed to do so.
IMPORTANT: Double-check
correct placement of utilities. Grasp
the sides of the dishwasher at the edges of the door panel. Tilt
dishwasher backward
on wheels and move dishwasher close to
cabinet opening.
NOTE: Do not push on the front of the panel or on the console.
Panel or console may dent.
Helpful Tip: Temporarily
tape utilities to the floor in the locations
shown to prohibit them from moving when dishwasher is moved
into the cabinet opening.
Check that water line is on the left side of opening and drain
hose is near the center of the cabinet opening.

Hide quick links:


Table of Contents

Table of Contents