Advertisement
Available languages
Available languages
mnstaH Leveling
Legs
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
1.
Prepare dryer for leveling legs
\
To avoid damaging floor, use a large flat piece of cardboard
from dryer carton; place under entire back edge of dryer.
Firmly grasp dryer body (not console panel) and gently lay
dryer down on cardboard.
2.
Screw
in leveling legs
diamond
marking _
Examine leveling legs, find diamond marking. Screw legs into
leg holes by hand, use a wrench to finish turning legs until
diamond marking is no longer visible.
Now stand the dryer on its feet. Slide the dryer until it is
close to its final location. Leave enough room to connect
the exhaust vent.
For mobile home use
Gas dryers must be securely fastened to the floor.
ELECTRIC DRYER POWER
HOOKUP = CANADA ONLY
E_ectdcal
Requ
Electrical
Shock Hazard
Plug into a grounded 4 prong outlet.
Failure to do so can result in death or electrical shock.
it is your responsibility:
[]
To contact a qualified electrical installer.
[]
To be sure that the electrical connection is adequate
and in conformance
with the Canadian Electrical Code,
C22.1 -latest edition and all local codes. A copy of the
above codes standard may be obtained from: Canadian
Standards Association,
178 Rexdale Blvd., Toronto, ON
Mgw 1R3 CANADA.
[]
To supply the required 4 wire, single phase, 120/240 volt,
60 Hz., AC only electrical supply on a separate 30-amp
circuit, fused on both sides of the line. A time-delay fuse or
circuit breaker is recommended.
Connect to an individual
branch circuit.
[]
This dryer is equipped with a CSA International Certified
Power Cord intended to be plugged into a standard 14-30R
wall receptacle. The cord is 5 ft. (1.52 m) in length. Be sure
wall receptacle is within reach of dryer's final location.
4-wire receptacle (14-30R)
[]
Do not use an extension cord.
If using a replacement
power supply cord, it is recommended
that
you use Power Supply Cord Replacement Part Number 344020.
For further information,
please reference the "Assistance or
Service" section of the "Dryer User Instructions."
Mobile home installations require a Mobile Home Installation
Hold-down
Kit. For ordering information
please reference the
"Dryer User Instructions."
Advertisement
