Outside Top Exhaust (Vertical Duct) - Kenmore 401.8504 Series Installation Instructions Manual

B. OUTSIDE TOP EXHAUST (VERTICAL DUCT)
B1. Adapting microwave blower For outside
top exhaust
1. Remove and save screw
2. Lift up the
that holds blower plate to / blower plate.
microwave. J
Blower Plate
Back of
"'""%_ Microwave
Screw
3. Carefully pull out the blower unit. The wires will extend far
enough to allow you to adjust the blower unit.
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the blower is
removed and re-installed.
4. Roll the blower unit 90 ° so that fan blade openings are
facing toward the top of the microwave.
BEFORE: Fan Blade Openings
Facing Forward
AFTER: Fan Blade Openings
Facing Upward
5. Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
6. Lower the blower plate into original position and secure
blower unit to microwave with the screw.
B2. Installation procedure For exhaust
adaptor and proper damper operation
check
]. Remove and save screw from the panel-outer
Roll _.Z1_
Exhaust Adaptor and Damper is
shipped assembled to the filler-upper.
2. Slide exhaust adaptor following the instructions show in
diagram.
3. Make sure tape securing damper is removed and damper
pivots easily before mounting microwave.
4. Lift damper and Re-screw at same location as (1).
* You will need to make adjustments to assure proper
alignment with your house exhaust duct after the microwave
is installed.
14