Outside Back Exhaust (Horizontal Duct) - Kenmore 401.8505 Installation Instructions Manual

C. OUTSIDE BACK EXHAUST (HORIZONTAL DUCT)
C1. Adapting microwave blower for outside
back exhaust
Remove and save screw that holds blower Plate to
microwave.
Blower motor screw
2. Lift up the Blower Plate.
Blower motor
of
Microwave
6. Place the blower unit back into the opening.
AFTER: Fan Blade Openings Facing
Back
End B
Blower motor screw
3. Carefully pull out the blower unit. The wires will extend far
enough to allow you to adjust the blower unit.
BEFORE: Fan Blade Openings Facing
Forward End_A %_[_/_e E_qd B
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the blower is
removed and re-installed.
4. Remove "Parts "A" with tin snips or pliers
Knockouts
5. Rotate blower unit counterclockwise 180 ° .
Before Rotation After Rotation
Back of Microwave
Back of Microwave
CAUTION: Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
7. Secure the blower unit to the microwave with the screw.
Back of
Microwave
Blower-Plate
From the Mounting Plate
screw
8. Attach the exhaust adaptor to the rear of the oven by
sliding it into the guides at the top center of the back of the
oven.
Adaptor
_"_ Guide
Guide From Blower motor screw (after attached the
exhaust adaptor)
Push in securely until it is in the lower locking tabs. Take care
to assure that the damper hinge is installed so that it is at
the top and that the damper swings freely.
C2. Mount the microwave oven
see page 12_13 (proceed on AI_A3)
16
8505 XAA 03807A-EN+MES.Jndb 16 2010-07-08 6:53:06