Make Electrical Connection - KitchenAid KXW4336YSS Installation Instructions And Use And Care Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Remove the terminal box cover.
3. Remove the knockout in the terminal box cover and install a
UL listed or CSA approved
A. Knockout
B. Terminal box cover

Make Electrical Connection

" strain relief.
A
B
4. Run the power supply cable or power cord kit (see the
"Accessories" section for information on ordering) through
strain relief, into terminal box.
A
C
D
E
A. Power supply cable or
power cord kit
B. UL listed or CSA approved
strain relief
C. Black wires
5. Use UL listed wire connectors and connect the black wires
(C) together.
6. Use UL listed wire connectors and connect the white wires (E)
together.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
7. Connect green (or bare) ground wire from the power supply or
power cord kit to yellow-green ground wire (F) in terminal box
using UL listed wire connectors.
8. Tighten the strain relief screw.
9. Install the terminal box cover.
10. Check that all light bulbs are secure in their sockets.
11. Reconnect power.
B
F
D. UL listed wire connectors
E. White wires
F. Green (or bare) and yellow-
green ground wires
9