Bar And Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna T435 Operator's Manual

Recommended original and replacement bar and chain combinations for USA
Following is a list of recommended cutting equipment for the Husqvarna chain saw model T435. The combinations of
power head, bar and chain have been tested and found to be in accordance with the kickback and vibration requirements
of ANSI B175.1–2000.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
Chain saw model Husqvarna T435 met the kickback performance requirements of ANSI B 175.1-2000 when tested with
the combinations of bars and saw chains listed below. The saw chain Husqvarna H36 is also classified as a low kickback
saw chain since it met the requirements for low kickback saw chain outlined in ANSI B 175.1-2000. We recommend to
use only the listed combinations of bars and chains for chain saw model Husqvarna T435. Other chain saw models may
not meet the kickback requirements when equipped with the listed bar and chain combinations.
Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for Husqvarna T435. The combinations of powerhead, bar and
chain meet all requirement outlined in the CSA Z62.1-03 Chainsaws and Z62.3-04 Chainsaw Kickback standards.
We recommend that you as replacement use the listed bars and chains of "Type C Low-Kickback Saw Chains" which are
available at your dealer.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a hard nose.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose
radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Bar and chain combinations

Recommended cutting equipment for chainsaw Husqvarna T435.
Length, inch Pitch, inch
12 3/8
14 3/8
16 3/8
Saw chain filing and file gauges
TECHNICAL DATA
MAINTENANCE
Bar
Gauge, inch Max. nose radius
0,050 7 T
0,050 7T
0,050 7T
Chain
Type Drive link count
45
Husqvarna H36 52
56
English – 39