Installation Manual For Electric Wiring - Haier AD092AMBHA Operation And Installation Manual

Haier duct type air conditioner operation & installation manual
Hide thumbs Also See for AD092AMBHA:
Table of Contents

Advertisement

INSTALLATION MANUAL FOR ELECTRIC WIRING

5. Electric wiring
Cautions: Use copper wire only.Parameters of connecting
line : H05RN-F 4G0.75mm
Power supply :1PH,220-230V~,50Hz, connect from outside.
Wiring methods:
1.Wiring method of ring terminal
For connecting line which end is a ring,its wiring method
as shown in the right figure: remove wiring screw and pass
it through the end ring of connecting line,then connect it to
the terminal block and tighten screw.
2. Wiring method of straight terminal
For connecting line which end is not a ring, its wiring method
as follows: loosen wiring screw ans insert the end of connecting
line totally into the terminal block,then tighten the screw and pull
the connecting line slightly to confirm that it is clamped firmly.
Crimp connection method of connecting line
After finishing wiring.connecting line must be fastened by
wire clamp,which pressed on the external sheath of the
connecting line, as shown in the right figure:
Wiring of indoor unit
Open air inlet grill
Take the leading end of connecting line
Connect connecting line according to wiring methods
and wiring diagram of indoor and outdoor unit
Fasten connecting line according to crimp connection
method of connecting line.
Reinstall air inlet grill.
1.Installation fixing
Fix outdoor unit installation bracket on the wall using a
M10 anchor bolt.Fix outdoor unit on the installation bracket
firmly using bot(M10) and nut, and keep it on horizontal level.
When installing on the wall or on the roof ,fix the bracket,
firmly to prevent earthquake or storm.
Be sure to use rubber-damping cushion to reduce unit vibration.
2.Installation of drain elbow
Installation of drain elbow.(Only for heat pump type air conditioner,
no drain elbow for single cooling type).If use drain elbow,please
install as shown in the figure.
Do not use drain elbow in cold place (temperature successively
below 0 C)
3. Connection of outdoor piping
Connect the connecting pipe according to the piping connection
method
4.Wiring connection
1.Open the wiring cover and loosen the wiring clamp.
2.Lead the connecting wire out and pass it through the wiring clamp.
3.Connect the connecting wire according to the wiring method and
diagram
4. Confirm the ends of wire are connected well, safe and correct.
5. After finishing wiring, press the connecting wire according to the
wire crimp connection method and reinstall the cover.
2
Wiring method of ring terminal
Correct crimp
connection of wire
Terminal block
to power supply
Power supply
Connecting wire
between inner and outer
21
1 ( L
)
Incorrect crimp
connection of wire
Crimp connection
clamp
Indoor unit
1
2
3
terminal block
Outdoor unit
1
2
3
terminal block
Terminal
Wire clamp
1
2
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents