Maintenance - Haier AB212XCEAA Operation And Installation Manual

Maintenance

[Clean air filter]
NOTE
When having to clean, don't dismantle
air-filter,otherwise may cause faults.
In the environment where there is too
much dust, air filter should be cleaned
for more times.
(about half a year one time)
1. Open inlet grill
Press the elliptical "PUSH" knob, the inlet
grill will automatically drop. (the inlet grill
is catched with two pothooks)
PUSH
Open two
pothooks
2. Open two othooks
3. Dismantle air filter
Air filter
4. Clean
CAUTION!
(A) Remove dust with vacuum filter.
Press the elliptical knob
the inlet grill will
automatically drop
Pothook
Drag the knob of
the grill back lift
the filter and take
down.
(B) Wash with water.
With too much dust, use soft brush and neutral
detergent.
Swing off the water, and then place in cool place.
5. Install air filter
(1) Put filter into protruding parts at the top of
the inlet grill.
(2) Connect the two pothooks with inlet grill
See 2
Connet the two pothooks with inlet grill
6. Close inlet grill
7. Press the filter signal return key on the
''
controller.
[Clean inlet grill]
1. Open inlet grill
Press the elliptical "PUSH" knob, the inlet
grill will automatically drop. (the inlet grill
is catched with two pothooks)
PUSH
Open two
pothooks
6
See 1.
''
Press the elliptical knob
the inlet grill will
automatically drop
Pothook