Sample Blank - Hach DR 5000 User Manual

Options
Send Data icon /
Send Data
Timer icon
Dilution Factor Off/On
Chemical Form
Edit
Save as User Program
Recall Data
Instrument Setup

5.5.5 Sample blank

Table 5 Barcode program options (continued)
Description
To send data to a printer, computer or USB memory stick (Type A)
This functions as a stopwatch. It helps to ensure that the steps of an analysis are correctly timed
(e.g. reaction times, wait times, etc., can be exactly specified). When the specified time has
elapsed, an acoustic signal is emitted. The use of the timer has no influence on the measurement
program.
A corrective dilution factor can be entered in order to take account of certain properties.
The number entered at the dilution factor prompt will be multiplied by the result to compensate for
the adjustment. For example, if the sample has been diluted by a factor of 2, enter 2. The default
setting of the dilution factor is turned off.
Note: When a dilution is in effect, the dilution icon will appear on the display.
Note: If undiluted samples are used, set the dilution factor off.
Some of the stored tests/methods allow to select the chemical form and the measuring range.
To modify an existing program
To store the selected parameters as a User Program, see
Call up saved measurement data, wavelength scans or time courses, see
page 35.
Basic data of the instrument, see
Turbidity and color in the sample matrix can falsify the results of a
photometric analysis. The interference factors come from the
sample or are created by reactions with the reagents.
The influence of turbidity and/or color can be eliminated or reduced
by taking a sample blank reading.
In the barcode mode, a special cuvette/vial (TNT919) containing
the sample blank is placed in cell compartment #1 after the sample
reading has been taken and is automatically measured. The
sample reading is then corrected by adding or subtracting the blank
value. The final result is displayed, with the message "After blank
value corr.".
Some barcode tests do not require a sample blank value to be
determined, as turbidity and color are dealt with during the test
section 6.1 on page
section 5.2 on page 23.
Standard Operations
61.
section 5.3 on
53