RCA RCD175 User Manual page 2

CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK).
N O U S E R S E R V I C E A B L E P A R T S I N S I D E .
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
Caution: This product utilizes a laser. Use of controls
or adjustments or performance of procedures
other than those specified may result in hazardous
radiation exposure. Do not open covers and do not
repair yourself. Refer servicing to qualified personnel.
WARNING: TO PREVENT FIRE OR ELECTRICAL
S H O C K H A Z A R D , D O N O T E X P O S E T H I S
PRODUCT TO RAIN OR MOISTURE.
CAUTION: DANGER OF EXPLOSION IF BATTERY
IS INCORRECTLY REPLACED. REPLACE ONLY
WITH THE SAME OR EQUIVALENT TYPE.
W A R N I N G : T H E A C A D A P T O R I S U S E D A S
DISCONNECT DEVICE AND IT SHOULD REMAIN
READILY OPERABLE DURING INTENDED USE.
IN ORDER TO DISCONNECT THE MAINS PLUG
FROM MAINS COMPLETELY, THE AC ADAPTOR
SHOULD BE DISCONNECTED FROM THE MAINS
SOCKET OUTLET COMPLETELY.
T h i s C l a s s B d i g i t a l a p p a ra t u s
complies with Canadian ICES-003.
CLASS 1 LASER PRODUCT
FCC information
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– C o n n e c t t h e e q u i p m e n t i n t o a n o u t l e t o n a
circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV
technician for help.
811-317591W012 EN & FR & ES IB OK Kelly.indd 1 811-317591W012 EN & FR & ES IB OK Kelly.indd 1
WARNING: Changes or modifications to this unit
not expressly approved by the party responsible for
compliance could void the user's authority to operate
the equipment.
This product complies with DHHS Rules 21 CFR Sub-
chapter J. Applicable at the date of manufacture.
Useful advice
• D o n o t u s e y o u r s y s t e m i m m e d i a t e l y a f t e r
t r a n s p o r t i n g i t f r o m a c o l d p l a c e t o a w a r m
place, as condensation may cause the system to
malfunction. If moisture forms inside this system, it
may not operate properly. To correct the problem,
turn off the power and wait about 30 minutes for
moisture to evaporate.
• Never leave the tray open as dust could cover the
laser lens and/or the tray could be bumped into
accidentally.
• Do not place the system near wet areas such as
bathrooms and pool side. Avoid storing the system
at humid places or near abnormally heated areas.
• Power is continuously supplied to the system.
To disconnect power completely, unplug the AC
adaptor from the power outlet.
• Ensure minimum distance around the apparatus
for sufficient ventilation. The ventilation should not
be impeded by covering the ventilation openings
This product
with items, such as newspaper, etc.
contains a low
• No naked flame source, such as lighted candles,
power laser device.
should be placed on the apparatus.
Technical information
Power Supply: DC 9V, 500mA
Unit Size ( H x W x D inches): 6.6 x 14.7 x 9.8
Rating Plate: Look for it at the bottom of the set.
For your records
In the event that service should be required, you may
need the model number. In the space below, record
the date and place of purchase:
Model No.
Date of Purchase
Place of Purchase
Service information
This product should be serviced only by those spe-
cially trained in appropriate servicing techniques. For
instructions on how to obtain service, refer to the
warranty included in this Guide.
EN - 1
9/16/2010 4:58:17 PM 9/16/2010 4:58:17 PM