Search By Alarm List - Mitsubishi Electric DX-TL5000E User Manual

Search by Alarm List

This unit stores the start time of alarm recording and
emergency recording in the alarm list when such recording
begins. This item is used to search the desired picture using
the list of alarm recording (emergency recording). The
search result displays in still frame playback of the single
screen display.
User Menu
1 Search
Search by Alarm List
3
D
1. Set the date, hour, minute, second, and sensor
step
number to be searched.
Latest: Displays the date and time of the latest
recording.
2. Select "Alarm List."
step
• The alarm list may take time to be displayed
completely when there are many list items or the HDD
has been added.
3. Select the alarm list you want to display.
step
• To change the device to be searched, set the desired
device in the <Select Source Device> (User
Menu Search Select Source Device).
When executing alarm list search while the "Alarm
area" and "Long pre-alarm area" are set, set the
playback area to "Alarm" and "LPA" respectively.
• "Sensor" display indicates the sensor number of which
the alarm signal is input.
• When the repeat recording setting for "Normal
Recording Area" or "Alarm Recording Area" (System
Menu Memory Data Management Setting for Main
Memory) is set to "Repeat Off" and there is an alarm
recording (emergency recording) at the end of the
HDD, that recording may not be stored in the alarm
list and that item may be missed.
• When the detection of the motion or the ground of the
ALARM IN terminal occurs numerously at the same
time, not all the start times of the alarm recording may
be registered in the alarm list. In this case, the sensor
of the lowest number is registered in the list.
• In the alarm list, items with the ALARM IN terminal
grounded are indicated in orange, items that were
detected with motion are indicated in white, items with
the EMERGENCY terminal grounded are indicated
in magenta, and items that were input with alarm
signal via communication are indicated in green.
• To clear the alarm list, erase the HDD data of which
the alarm recording is recorded (System Menu Data
Clear). Beware that executing it erases all the data of
the HDD contained the picture data.
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Basic operations
Alarm List
• Alarm list search is not performed if there are no index
signals.
• When an alarm recording (emergency recording) is
started while displaying the <Alarm List>, exit the
<Alarm List> once and then display it again. The new
item will be added to the list.
1, 2
steps
3
step
17