Controlpanel - Kenmore 580.54501 50 Pint Owner's Manual

7
CONTROLPANEL
4 3
1. POWER key
Pressing this key once turns the dehumidifier "ON" and pressing againturns the dehumidifier "OFF".
2. HUMIDITY CONTROL keys
Press to select the desired humidity setting.
• /_. : Used to raise the desired humidity setting.
• V : Used to lower the desired humidity setting.
• The desired humidity can be selected within e range of 35% to 70% Relative Humidity in increments of 5%.
• If you press the V key once again at 35% Relative Humidity, continuous "On" mode is selected and "On" appears in
the display window. In "On" mode the unit operates continuously, regardless of humidity conditions.
3. HUMIDITY SETTING display
Displaysthe selected humiditysetting.
4. FAN SPEED key
Press to set the fan speed as "High" or "Low".
• Pressingthiskey changesthe fan speed from High--, Low --, High.
• The selected fan speed is indicatedbyindicatorlightsmarked "High" and "Low'.
5. ENERGY TIMER key
Press to selecttimedoperationcycle.
• Pressing this key selects EITHER THE 3 OR 6 HOUR TIMER MODE. The Timer indicatorlightwill shiftfrom3 hour
On/Offto 6 hour On/Off. The unitwill run for either 3 or 6 hours,andthen shutoff completely for 3 or 6 hours. The
cyclerepeats untilyouchange the setting.To turn offthe ENERGY TIMER function, press key untilindicatorlights
are both "Off".
• If ENERGY TIMER function is not selected, unit operates until desired humidity setting is reached.
6. BUCKET FULL Indicator
Thislight glows when the bucket is full and needs to be emptied. It also glows when the bucket is not properly
positioned. When bucket full indicator light glows, the compressor and fen will tum "OFF".
7. AUTO RESTART
• The Auto Restart function automatically restarts your dehumidifier once power is restored. The fan will immediately
begin to run for approximately 2 minutes, and the unit will operate at the previoushumidity setting. After two minutes,
the compressor may also start based on the humidity conditions in the room. Once the target humidity setting is
reached, the fan and compressor will shut off.
TO OPERATE THE DEHUMIDIFIER:
1. Plugthe power cord into the electdceloutlet. Press the POWER key.
2. Set the Humiditycontrolanywherebetween 35% to 70% for normal operation.
• For less humidity, p ressthe V HUMIDITY CONTROL key.
• For higher humidity, presstheA HUMIDITY CONTROL key.
3. Pressthe ENERGY TIMER key if desired,to set the amount of timefor whichyouwantthe unit to cycle On andOff.
The time can be set for3 hoursor 6 hours.
4. If youwant to changethe fan speed,pressthe FAN SPEED key. Each time the FAN SPEED key is pressedthe fan
speed changesfrom High _ Low -, High.
5. Press the POWER keyto stop the unitmanually.
-7-