X10 MT12 User Manual page 7

Setting the clock:
When you first plug in the Mini Timer, the display will flash.
Set the MODE SWITCH to CLOCK SET.
Press and hold + on the TIME key to advance to the correct
time. If you go too far, you can use - on the bottom of the key
switch to go back.
Wake Switch - In the ON position, an internal wake up buzzer will
sound at the time programmed for module 1. You can turn it off by
pressing any button to obtain the "SNOOZE" feature, repeating the
alarm again 10 minutes later. Move the WAKE switch to OFF to end
the alarm. Return it to ON to resume the alarm setting.
A quick look at the Mini Timer
The keyboard on
the Mini
includes:
Mode Switch - Use
this switch to set or
review a
event, change the
House Code, or set the clock. Also sets the time for the internal
alarm buzzer.
On/Off Buttons - Use the four sets of ON/OFF buttons to turn your
modules on and off instantly.
Time/Adjust Key - Use this to set the time clock and each
programmed event. Also used to Brighten or Dim a selected Lamp
Module in RUN mode.
Wake - Use this to turn on the internal alarm buzzer.
All Off - Use this to turn off all modules (All Units Off).
Mode Button - Use this to set your programmed times to occur
Daily, Once, or random in the Security mode.
All Lights On - Use this to turn on all Lamp-/Dimmer- Modules (not
included).
Module Selector Switch - Use this switch to select modules 1-4 or
5-8.
Clear - Use this button to cancel the programmed time.
BMB HOME
Timer
timed
7 rev. 01-10-05